Haier HCH2100ACS Bedienungsanleitung PDF herunterladen (Seite 9)

ELECTRICAL REQUIREMENTS

Observe all governing codes and ordinances.

Ensure that the electrical installation is adequate and in conformance with National

Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Standards C22.1-94,

Canadian Electrical Code, Part 1 and C22.2 No. 0-M91 (latest edition) and all local

codes and ordinances.

If codes permit and a separate ground wire is used, it is recommended that a

qualied electrician determine that the ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association

1 Batterymarch Park

Quincy, MA 02169-7471

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

It is important to make sure you have the proper electrical connection.

RECOMMENDED GROUNDING METHOD

A 120 volt, 60 Hz, AC only, 15-amp fused, grounded electrical supply is required. Use

an outlet that cannot be turned o by a switch. Do not use an extension cord.

NOTE: Before cleaning, or removing a light bulb, turn vent hood o, and then

disconnect the vent hood from the electrical source. When you are nished,

reconnect the vent hood to the electrical source.

INSTALLATION INSTRUCTIONS

PREPARE LOCATION

•

It is recommended that the vent system be installed before hood is installed.

•

Before making cutouts, make sure there is proper clearance within the ceiling or

wall for exhaust vent.

•

Check your ceiling height and the hood height maximum before you select your

hood.

1. Disconnect power.

2. Determine which venting method to use: roof, wall, or nonvented.

3. Select a at surface for assembling the range hood. Place covering over that

surface.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

Keine Kommentare

Haier HCH2100ACS Bedienungsanleitung Seite 9